Owens Corning Insulation Removal in Fresno: What to Know First
Independent Owens Corning insulation removal in Fresno typically takes one to two days from first call to finished attic, depending on square footage and how much material is up there. Most Fresno jobs we quote run between $1.50 and $3.75 per square foot for full removal, haul-off, and sanitation, with the final number set before a single tool comes off the truck. We are an independent Owens Corning service provider, not a factory-authorized dealer, which means we answer to you and the written guarantee, not a corporate script.
This page is for Fresno homeowners and property owners sitting on Owens Corning fiberglass batts, blown-in loosefill, or older board stock that’s compressed, pest-soiled, water-damaged, or just not doing the job anymore. If your attic smells like a hot pizza box every July and your AC never cycles off, that’s data. Call (559) 666-2260 and a real person picks up, any hour.
Key takeaways:
- We remove Owens Corning fiberglass and mineral wool products from any Fresno attic, including tough vaulted and low-clearance spaces.
- Written price before work starts. No door-price revisions, no surprise line items.
- Every removal carries the 365-Day Done Right Promise in writing.
- We’re independent. We don’t push Owens Corning replacement just because the label says so. If Reflectix radiant barrier or a Johns Manville product fits your Fresno attic better, we’ll say so.
How Owens Corning Products Fail – and How We Fix Them
Owens Corning makes decent material. But Fresno’s climate, rats, squirrels, and thirty years of heat-soak will do to any insulation what time does to everything. Here’s what we actually find up there.
- Blown-in Pink Fiberglas loosefill settling and losing R-value. Owens Corning pink loosefill is common in Fresno ranch houses built before 2000. After decades, it settles below the top of the ceiling joists, dropping from R-38 toward R-19 or worse. We see it every week in the Tower District and Woodward Park. The fix is complete removal, air sealing, and a fresh blown-in layer to current code. You can’t fluff settled fiberglass back to its rated performance.
- Pest-soiled fiberglass batts. Rats and squirrels treat Owens Corning batt stock like free bedding. Once rodents tunnel through and leave waste, the batts become a health concern and lose thermal value. We remove the contaminated material, disinfect the cavity where necessary, and tell you plainly if the pest source needs a separate contractor before we put anything new back.
- Water-damaged batt and board products. Owens Corning fiberglass batt and older board insulation that’s been through a roof leak or AC condensate overflow compresses flat and stays flat. Mold can grow on the facing. We’ve pulled matted pink batts from Fresno attics that measured an honest R-11 though the label said R-30. Water wins. We remove it and dry the substrate before re-insulating.
- Improperly installed faced batts. Owens Corning kraft-faced batts installed facing the wrong side or left exposed in an unvented attic create condensation points. The facing acts as a partial vapor barrier and traps moisture against the drywall. We correct it by removing the failed run and installing unfaced product or blown-in with proper air sealing.
- Older Owens Corning attic board products. Some Fresno homes built in the 1950s through early 1970s have rigid attic board stock from Owens Corning that’s now brittle, dusty, and impossible to re-use. It cracks when moved and sheds fine fibers. We remove it in sections, bag it on site, and run a full vacuum pass before any new material goes down.
Our Owens Corning Insulation Removal Process
We don’t arrive with a truck and a vague plan. Here’s the full sequence on a Fresno Owens Corning removal, from call to cleanup.
- 1
Call and assessment. You call (559) 666-2260. We ask about square footage, attic access location, what you’re seeing or smelling, and any known leaks or pest issues. Then we schedule a site visit inside a specific window.
- 2
Attic inspection and written price. We go up, measure, photograph, and test the existing Owens Corning material. You get a written line-item price for removal, haul-off, and sanitation before any work begins. That number is the number.
- 3
Containment and removal. We set up containment at the attic access, run extraction lines if it’s blown-in, hand-pull batts in tight sections, and bag everything in heavy-mil disposal bags. We don’t drag loose fiberglass through your hallway.
- 4
Vacuum and sanitation pass. After removal, the attic floor is vacuumed with HEPA-filtered equipment specific to insulation dust. We remove dust from ceiling joists, top plates, and recessed light housings where accessible.
- 5
Air sealing check and material decision. We tell you what we found and what’s needed. Now is the cheapest time to air seal penetrations. We’ll recommend Owens Corning replacement only if it’s the right product for your Fresno attic; otherwise we’ll quote Reflectix radiant barrier, Johns Manville, Knauf, or another brand from our eight-brand lineup.
- 6
Re-insulation and walkthrough. We install the approved material to the R-value we agreed on, photograph the finished work, and do a walkthrough with you. The 365-Day Done Right Promise goes in writing, including a free second visit if anything fails within the year.
What Owens Corning Insulation Removal Costs in Fresno
Most Owens Corning attic removal jobs in Fresno run from $1.50 to $3.75 per square foot for the removal and haul-off alone. That puts a typical 1,200-square-foot Fresno attic between $1,800 and $4,500 before we talk about what goes back in. Add new blown-in insulation and the total commonly lands between $3,800 and $9,000, depending on target R-value and how much air sealing we do.
What moves the price: attic height and access difficulty, how many roof planes you have, how much material is up there, whether there’s pest contamination requiring sanitation, and whether old board stock needs to be cut out in sections. Fresno attics with tight hatch access or steep roof pitches take longer. The written price covers all of it. Call (559) 666-2260 and we’ll get you a real number after a site visit, not over the phone.
Why Fresno Homeowners Call Alden Insulation Fresno for Owens Corning Work
Alden Insulation Fresno is independently owned and operated, held to The Garrison Standard. That’s a written code, not a slogan: the price you approve is the price on the invoice, the crew that shows up is background-checked and in uniform, and the work carries a written 365-day guarantee. If it fails in that year, we come back at no charge. That’s the whole arrangement.
Bryce Holloway grew up in Los Angeles and learned his trade at Los Angeles Trade-Technical College before spending the better part of two decades learning what insulation actually does to a house across every season. He and the crew have run Owens Corning removal jobs from older bungalows in the Tower District to newer builds out past Shaw Avenue, and they know exactly what a Central Valley summer does to an attic with inadequate R-value. Good insulation doesn’t make the news. That’s the point.
We install and remove products from Owens Corning, Johns Manville, Knauf, Rockwool, CertainTeed, Icynene, Demilec, GreenFiber, and Reflectix. You research the material before you commit. We hand you the written price and then the written guarantee.
FAQs
No. Owens Corning’s limited warranty covers manufacturing defects in the product, not the labor to remove failed, soiled, or water-damaged material, and not the conditions that caused the failure in the first place. Once insulation is installed, removal and replacement are the homeowner’s responsibility. Call (559) 666-2260 and we’ll inspect what’s actually up there and tell you plainly what’s covered by the manufacturer and what isn’t.
Yes, we remove Owens Corning material and leave the attic clean and empty if that’s what you need, though we’ll tell you the honest consequence: an uninsulated attic in Fresno can hit 140 degrees in August and pull your AC bill up hard. We’ll remove and haul off without installing anything new, and the written guarantee still applies to the removal work itself.
Almost always. Doing removal and re-insulation as one job means one mobilization, one containment setup, and one cleanup, so the combined price is lower than splitting the work between two visits or two contractors. We quote removal and re-insulation as a single line-item job when that’s what the attic needs. Call us for a free written estimate.
Most Fresno Owens Corning removals are done in one day, with larger or access-tight attics taking two. We’re on site inside the window we scheduled, background-checked and uniformed, and calls are answered by a live person 24/7. If you need the insulation gone before a roofer or electrician arrives, tell us when you call.
Yes, and this is one of the most common changes we make in Fresno attics. We remove the failed batts, air seal the penetrations, and blow in fresh loosefill to the R-value we agree on in writing. You get better coverage in irregular bays and a cleaner thermal boundary than old batts could provide.
Need a real price for Owens Corning insulation removal in Fresno? Call (559) 666-2260. A live person answers, any hour, and we’ll schedule a site visit with a written estimate before any work begins.
Written by Bryce Holloway, Owner, Alden Insulation Fresno at Alden Insulation Fresno, serving Fresno and nearby areas.